Dillon 550B Powder Measure Problems
Dillon 550B Powder Measure Problems. All of my metering problems w/ unique and red dot went away after i polished up the powder hopper and added a low powder sensor to keep the powder from bouncing around. I have run 5,000 9mm rounds through my 550b with no problems.
While the measure works well, the sliding upper half of the measure is a loose fit to the lower fixed part. The lever on the powder crank has an edge bent in towards the. The control of that fit is the plastic bushing on the long delivery tube.
The Lever On The Powder Crank Has An Edge Bent In Towards The.
I am gradually working into using the progressive. I did not add the powder measure. Typical dillon 550 primer feeding problems.
I Have Run 5,000 9Mm Rounds Through My 550B With No Problems.
I have been loading powder using a rcbs chargemaster. This comes up a lot on the dillon forums, the most common solution is to take the powder assembly apart and clean the throat of the aluminum part. I had a lot of good advice and help from the comments on my last video about this powder measure.
First Of All, Your Press Looks A Lot Like Mine, Which Is An Early 550 (Not B).
While the measure works well, the sliding upper half of the measure is a loose fit to the lower fixed part. All of my metering problems w/ unique and red dot went away after i polished up the powder hopper and added a low powder sensor to keep the powder from bouncing around. I just go over it again and try.
The Control Of That Fit Is The Plastic Bushing On The Long Delivery Tube.
Gun powder is very abrasive. Sooner or later the bar in you powder measure will wear enough to allow some powder to get between the bar and the measure body. Folks, i need some help figuring out a powder measure problem.
Post a Comment for "Dillon 550B Powder Measure Problems"